Difference between revisions of "Trim Network Link"
(Created page with "File:TrimNetworkLinkButton.png Category:Button") |
|||
| (14 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | [[File:TrimNetworkLinkButton.png]] | + | [[:Category:Toolbar Link Editor|Toolbar '''Link Editor''']] → [[File:TrimNetworkLinkButton.png]] |
| + | |||
| + | This button can be used when a TMC-Link contains a Network Link that is longer than the TMC-Link itself. | ||
| + | |||
| + | (Image 1: The points have been placed next to the road for better visibility) | ||
| + | |||
| + | Proceed as follows: | ||
| + | |||
| + | # Add the Network Link to the TMC-Link as you would usually do. | ||
| + | # Now activate the Trim-button. The cursor will turn into a + symbol. | ||
| + | # Click on the Network Link there where it becomes too long (Image 2: green arrow). | ||
| + | # Now move the mouse. The cursor should turn into an arrow with a + symbol beside it. | ||
| + | # Click on that part of the Network Link you wish to keep (Here it would be the part on the left-hand side). | ||
| + | # Now only this part of the Network Link should remain (Image 3). | ||
| + | |||
| + | The remaining part of the Network Link will automatically be added to the next TMC-Link where it then can be trimmed again if necessary. A Network Link can be trimmed several times. | ||
| + | |||
| + | [[File:Trim1.png|600px]] | ||
| + | |||
| + | |||
| + | |||
| + | |||
[[Category:Button]] | [[Category:Button]] | ||
| + | [[Category:Toolbar Link Editor]] | ||
Latest revision as of 11:04, 29 October 2013
This button can be used when a TMC-Link contains a Network Link that is longer than the TMC-Link itself.
(Image 1: The points have been placed next to the road for better visibility)
Proceed as follows:
- Add the Network Link to the TMC-Link as you would usually do.
- Now activate the Trim-button. The cursor will turn into a + symbol.
- Click on the Network Link there where it becomes too long (Image 2: green arrow).
- Now move the mouse. The cursor should turn into an arrow with a + symbol beside it.
- Click on that part of the Network Link you wish to keep (Here it would be the part on the left-hand side).
- Now only this part of the Network Link should remain (Image 3).
The remaining part of the Network Link will automatically be added to the next TMC-Link where it then can be trimmed again if necessary. A Network Link can be trimmed several times.
